Uncategorized

Newly laid asphalt surfaces should cure at least nine months before applying SEAL-TITE to al- low for the proper setting up time. Easy To Use SEAL-TITE comes ready to use.…

Ready to apply as it comes from the pail. No thinning is required. The high content of the pure aluminum pigment will settle during shipment but is easily stirred back…

DIRECTIONS TO USE: Ready to apply directly from the container. No mixing or thinning required. It can be applied by brush, roller or spray to interior walls, decking and ceiling.…

DIRECTIONS FOR USE POURABLE CRACK FILLER is manufactured exclusively for the purpose of repairing small cracks in outside asphalt and concrete paving. For a quick, economical maintenance approach to control…

EASY TO USE STEP 1 – Locate and mark all chuck-holes and broken areas. Brush or sweep all dust and loose aggregate from each chuckhole. Clean each one down to…

APPLICATION: SURFACE PREPARATION: Clean surface for repair, removing loose debris, disintegrated concrete, oil, grease and dirt. Flush the area thoroughly REXROC is a one component cement that sets up ready…

After thoroughly mixing with water, pour the material into the hole to be repaired and level the patch with the surrounding concrete. Use a mortar-type mixer for large jobs. For…

Minimum Coverage The following coverage rates are minimums only. If asphaltic roofs are dried out, apply a coating of ROOF PRIMER before the application of FIBERED A.R.C. . Metal Roofs…

Shake well before using. Clean surface thoroughly. Hold can 6 to 8 inches from surface and apply even, thin coats. Allow 1 to 5 minutes for adequate drying. The concentration…

DIRECTIONS FOR USE Shake well before using. Remove protective cap. Hold can 6 to 8 inches from surfaces to be sprayed. Apply an even coat to surface. Turn on machinery and…